Well kershaw designs has the bearings also, and will install them too, but they don't advertise the 6XL Feigao

does any one have a write up on how to change the bearings?

this would be my first time ever donig it and i dont want to mess it up.

nvm i found it.

I changed out a set on a used 540c 9xl I bought - brgs felt gritty. The removeable bell end was not a prob - they are light pressfits. That end was done in about 5min.

It was the drive end that was a pia.

well i think im going to do the dual 6xl motors on dual 4cell lipos and im goign to change out the bearings in them just in case i want to up the amount of cells im using. like maybe go to 5 or 6 cells.

ok thanks guys for th help

6XL on 8 LiPos, no problem.







As long as there wired in parallel!