Flex until it brakes?

That's perhaps the best test to try :yes:

I also did this for my rustler. I just used velcro to mount the rx and the esc. To mount th battery I drilledout a few holes and put a screw through the hole. I made a strap(made of lexan too of course) to go across and it would eb secured down by screwing a locknut on the screw. Wasn't the fastest way but It worked. You could always use associated battery cups(the ones the use for FLM chassis on rustlers).

Hope this helps

A 20 dollar walmart special jigsaw with a coarse tooth blade will be the best way to cut lexan/plexi that thick. Not really sure if that is the best material to use for a chassis... That being said I do have a few bombproof chassis and I know that MM has a fondness for clear plastic! As far as that pede chassis goes, use some 1/2" al angle and screw it along the sides to enhance the rigidity. You could actually ues that to make the sides for the battery tray... 2 for the price of 1!

Sounds good guys. Haven't done much, been pissed at my sled, and in bike mode right now. Gotta save for upcomin MTB season.

MTB??? Midget Testicle Bashing? You guys up north do some weird stuff...

MounTain Bike Sheesh, you think im a perv er somthin?

:lol: You're way to serious.


Sorry Linc, I guess not everyone gets your jokes. :neutral:

I would say about 6 out of 5 people get my jokes...

Lol, i knew he was jokin, Thats why i said sheesh

speaking of which how is your midget training going?

Haha

Had to give that up. My shins were taking a beating.

yes, flex it til it breaks. if it breaks, its plexiglass, and better now than out on a run, with expensive electronics. if it dont break, its lexan. i literally took a strip of lexan and tied it in a knot, pulled it as tight as i could. that crap just dont break. also, how was drilling holes? i tried drilling into a piece i thought was lexan, but it was plexiglass, and it spider cracked