That's very cool. are you going to make your own driveshaft?

nope, im gona use one of my left over revo drive shafts with the stock revo yoke on one end which is 6mm bore for the wk axle and on the other end ill put an old e-maxx trans side drive yoke on it which is 5mm bore for the ax-10 trans.

Lookin good! I hope you have a good connection on those plates to the chassis. There's going to be some serious force there.

Have you looked on www.rcshortcourse.com ? Lots of good info there. :smile:

ill look around that website. for those plates i think i will screw some of those steering servo stand offs or mounts or whateva there called and then screw em into the bottom of the chassis