Something I was wondering - Will this work for the pede as well? As i've had a stadium truck and want something more off-road as my T4 doesn't cope as well as i would have liked.

Yes, it should. The Rustler/Stampede use the same axles, arms, and transmission case. In case you didn't read the whole thread, I'll let you know the Ofna dogbones don't fit. You'll need the HPI dogbones or like-sized versions.

My other link didn't work, so here is the other version.

-HPI Cup Joint 7x19 http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXFYV1 (need 2)
-HPI Axle 5x41x7mm http://www2.towerhobbies.com/cgi-bin...?&I=LXFYU6&P=7
-HPI Dogbone 7x86mm http://www2.towerhobbies.com/cgi-bin...?&I=LXFYU8&P=7
-HPI Screw Shaft M4x2x12mm http://www2.towerhobbies.com/cgi-bin...?&I=LXDLG8&P=7
-5x8mm washers (for shimming axle) http://www2.towerhobbies.com/cgi-bin...?&I=LXJJ88&P=7


Optional:
-HPI Heavy Duty Cup Joint 7x19 http://www2.towerhobbies.com/cgi-bin...?&I=LXJEZ3&P=7 (need 2)

I used Ofna diff cups and Durtrax raze dogbones. they have been in the rusty with a Feigao 7L for over 1.5 years with no failures at all. Here is a write up I did back then:
http://www.rcbros.com/forum/forum_po...?TID=2003&PN=1

soon after that, FLM came out with a Kit. I am surprized Mike does not sell them:
http://www.rcbros.com/cart/Scripts/p...idCategory=140

Thanks guys, your a big help.

I can't seem to figure out what the difference is between the 2 different kits at rc bros. does anybody know?

the top one says high strength steel and costs a little more.