RC-Monster Forums - BOR's FLM stampede

RC-Monster Forums (https://www.rc-monster.com/forum/index.php)

- Brushless (https://www.rc-monster.com/forum/forumdisplay.php?f=12)

- - BOR's FLM stampede (https://www.rc-monster.com/forum/showthread.php?t=9765)

Quote:

Originally Posted by generalg (Post 144079)

Could you do me a favor and measure the wheelbase and width both front and rear of the truck? Those arms look very wide, I really like how it all looks. Wondering how much wider the arms are over stock or compared to a Jato front end setup etc.

The extended arms aren't too much wider allthough thay make a big differance in look and performance!

Quote:

Originally Posted by generalg (Post 144079)

lincpimp, sent you a PM on your pede.

BlackedOutREVO, I figured you wouldn't want to sell it yet... lol. Doesn't hurt to ask though right?

Could you do me a favor and measure the wheelbase and width both front and rear of the truck? Those arms look very wide, I really like how it all looks. Wondering how much wider the arms are over stock or compared to a Jato front end setup etc.

Thanks

Nope, I went out and ran my touring car today, and the poor LRP cought fire:diablo: so now im F-ed..... Looks like I will be using a MM in my touring car to race with lol:neutral:

I have to find a ruler or something, and then I will tell you

The wheel base is 1 in longer then stock

and the arms are half a inch longer, and if you use the FLM nitro pede/rusty caster's then that will widen it so its just as wide as the rear (so you can use the same offset rims) and they fit no mods, this one was the elec ones.... I dont like them... I want to use the same rim

Quote:

Originally Posted by generalg (Post 144079)

lincpimp, sent you a PM on your pede.
Thanks

You have a reply. Thanks