Here is a step by step guide from FLM's site:
http://www.fastlanemachine.com/Publi...3/Default.aspx

Thanks for the link.
Now it shows some delrin stops,I dont have any stops in my kit :neutral:
Do have a couple of these aluminum mounts left over.

check the stuff in the red and blue boxes - the o-rings dont fit any of the outdrives, so not sure what they are other than all of the o-rings are for the battery hold-down?

http://i211.photobucket.com/albums/b...MChassis01.jpg

:lol: dan i would hope you figured out where the drive shaft goes :lol:
The big o rings are for the battery hold down, small for the outdrives.
You are correct on the stock shock mountings.
the shims and 2 spacers i am not sure because i never used the LST shocks.
In the blue, the washer is a spare, The other 2 mounts are used to hold the skid plate on. (you may have got extras it you already used all the holes.)

Ok now that we got his extras figured out lol, what about these delrin pieces for the battery stops? I got nothing in delrin do I need to contact FLM?

ah yes if you dont have them you are suppose to. But in all honestly mine broke on the first jump and i made my own tray like mechanism to hold the battery. I think you should jsut fab your own that will hold up better.

I didnt get the delrin stops either man...
I'm thinking of using those 2 spare mounts i have left over - one on the TVP and one on the chassis 'deck' - and will screw a square piece of acrylic to them both =)

thanks for the help future! -lol-

you know i am thinking those are not spares then. They may have done away with the delrin mounts and put these in place which would be much better IMO. Wont break off then. I would use them as the stops if i were in your position.