RC-Monster Forums

RC-Monster Forums (https://www.rc-monster.com/forum/index.php)
-   General Discussion (https://www.rc-monster.com/forum/forumdisplay.php?f=20)
-   -   Tekno Announces Release of New Lektron Motors (https://www.rc-monster.com/forum/showthread.php?t=19997)

Freakycrawler 08.14.2009 05:19 PM

Quote:

Originally Posted by teknorc (Post 313148)
These are not intended for truggy use. They are just a tad too small. Go with a 1515 or 1512 based motor instead (1515/2.5D or 1512/3D).

Thanks you very mch, nice and quick reply'ed also:intello:

I will look into the ones you advise.

Thanks you guys

Topas 09.10.2009 04:53 PM

Do I need a fan on the motor (Lektron 2200) in a Losi 8ight 1.0 Buggy ? After 10 minutes it is about 74 degrees C hot (gearing 45/15)

danhfvcsd 09.10.2009 06:30 PM

Quote:

Originally Posted by Topas (Post 319740)
Do I need a fan on the motor (Lektron 2200) in a Losi 8ight 1.0 Buggy ? After 10 minutes it is about 74 degrees C hot (gearing 45/15)

I wouldn't think so... you could gear down the pinion a tad if you have the room for it, but a fan wouldn't hurt it if you wanted to run one i think... My tekno neu 1512 gets around those temps in my RC8, and it's fine =)

Topas 09.11.2009 01:43 AM

Quote:

Originally Posted by danhfvcsd (Post 319758)
I wouldn't think so... you could gear down the pinion a tad if you have the room for it, but a fan wouldn't hurt it if you wanted to run one i think... My tekno neu 1512 gets around those temps in my RC8, and it's fine =)

But it isnīt a neu 1512 ...;) The manual tells : Donīt let the temperature go above 78 C ... So if I drive a 20 minutes main I will run into problems ...

danhfvcsd 09.11.2009 02:32 AM

thats a good point - my temps are almost at that after a 20 minute main, not 10 minutes....

Try gearing down on the pinion, and lose some weight if its possible... it should run a bit cooler then... or simply add the fan and see how it goes =)


All times are GMT -4. The time now is 03:00 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.