but then I have to run HUGE 30+ teeth pinions. I should be able to fit a 4s on it, but I think it will be too much wight...

:grrrrrr:still no metal:grrrrrr:

A 6s is a stout motor... I ran a 7s in a rustler way back and it could push that thing around easily. Plus it would pull over 100amps on 3s. Hope you have some good lipos... And a fan for the MM...

It pulled over 150 amps in my drag emaxx...

I'm using a 2s
IDK, but a tekin RX8 auta do the job:lol:

I have 1 esc between the maxx, and this....

well, aparently they can't get 7075, so they went and ordered some 3003(I think)....:grrrrrr::grrrrrr::grrrrrr::grrrrrr::grr rrrr::grrrrrr::grrrrrr::grrrrrr::grrrrrr::grrrrrr: :grrrrrr: apparently its the closest they could get

the 3003 alloy still hasn't come yet:grrrrrr::grrrrrr:

the 9l motor is going in the jato cus an RX8 combo is on its way to me for my maxx:yipi:
will this motor have enought power to turn preaty much any gearing on a 4s??

found some 1/8 buggy adapters for it they should give the right offset, but everyone is out of stock:diablo:

well, after 3 WEEKS the alloy has finally come in...

the chassis should be done tomorrow:party:


I decided you use a novak HV 4.5 instaid because of the 1/8 shaft, its should have enough power:oops:

I'v kinda given up on the whole "corr truck" thing, but here are some pics


(2) protek 4000 15c 2s lipos
Novak HV 4.5
towerpro mg955
spektrum
18/56 gearing
1/8 buggy adapters

first time out I nailed the throttle and craped my pants:oops: uber fast:yes:
spegetty wires anyone??:lol:
how bout those pretty pink zipties holding the batts in:lol::whistle:
http://i272.photobucket.com/albums/j...o/IMGP4982.jpg

http://i272.photobucket.com/albums/j...o/IMGP4983.jpg



EDIT: without those huge caps on my range is only 100-150ft:whip:

did I mention its fast??:angel:

That looks decent, but invest in a better ESC and go to 2s and gear up.

I'v got an RX8 in my maxx, but for $25 for a working esc and motor...:yipi:

haven't had any heat probs yet, but then again I havent ran it for more than 5min...

but on a 4s that motor sounds wicked:bad: and 2s is just too slow:lol: