Have you checked your servos? I have heard of them causing some glitching and such.

Yeah, it does it without the servo even plugged in.

Have your tried a different esc?

Well this is the only sensorless ESC I have and the system works fine in another truck so I don't know what to think. Unless there is something wrong with it that only affects it when it's in this particular truck, which I doubt.

TRy a reciever pack and an antenna tube and not running the antenna across the esc.

I would try something like removing all the electronic components (except the motor of course) while still hooked up and try to run it and then just add components to see which causes the problem.

I tried a receiver pack and tube with the antenna in different locations. Thanks though.

I'm going to try just a servo with a receiver pack with the esc unplugged and see what happens.

Check around for any metal to metal rubbing as well. It can cause you headaches.

Yeah I checked all of the screws and other than that there isn't much metal-metal. I think I'm going to take the whole system and sit it on the ground and see if it does it, then put each one in until something happens, like squee said.

Well I tried laying everything out next to the car and putting things in one by one. I can't get it to consistently not work so I don't know what's causing it. It has to be the controller in some form or another. The question is do I send it to Mtroniks or try (buy :mad: ) another controller first to see if it does it?

did you try to reprogram it? I have seen the esc do some strange things cause it lost memory or something.

Yeah every time you plug it in you can choose to program the endpoints and I've done it over and over. Now it won't work in another truck either and it's acting strange like the throttle or brake wouldn't work, then they started working but reverse just barely moves at cog speed. I think it has to go back.

sounds like you found the problem. Just have to get it fixed now.

I just emailed Mtroniks so we'll see what they say.

I've had that happen to my Mtroniks Truck before. After reprogramming the throttle and brake endpoints, it would always work again.