Castle Link is now 3.01.

It does have new FETS ... not sure what else might be different

So other than the new FETS, do we know the extent of the changes to the MM? and whats different about the new FET's in the board?

The new FETs have 1/2 the resistance of the old ones...that is the only change.

That's nice to hear! Less Rdson means less heat for a given current (assuming nothing else like switching speed was changed).

While you're on here, any idea when/if a software fix for slotted-stator motors like Neu and Novak will be released?

BUT guess what Castle Out of Stock again for all warantee replacements...

It looks like these new boards have heavier copper too, which can only help with efficiency: :)

"Be aware this is the NEW board -- lower RDSon FETs, 30 FETs, and heavier copper.

Thanx!

Patrick"

(From RCZ)

The Feigao 8XL, the RC-M pinions and other bits have all arrived- still waiting for the Bishop Power Products MM ESC. It's been a couple of months now- I might give up and get an ESC from Mike (MGM?) or OEMRC.

really? you should send Troy (bpp owner) an email. He's usually super fast about shipping, unless its out of stock. And it shouldn't take months to re-stock the MM. Give him an email or call him. He's very helpful and a good guy.

rschoi_75
Thanks a lot- I sent one off to Troy just a few hours ago- let's hope it's not far away!!
Kind regards
ICUBoy

The MM arrived 48 hour ago. NOW to try it out!!! I have learned heaps from this forum- I hope it don't all go SPUTZ on me now!!! MM/ 8XL/ 14 cells or A123s (en route)