Looks great. That motor is crazy long!!!!! I would look at finding a way to give it a little support in the back. Take some of the stress of of the motor mount in landing jumps and such.

Cant wait to see that thing run.

The aluminium used is 7075 t651, I will see in the first test if it's enough strong.The motor's length is about 11 cm
Thanks

Hardstyle, I have you some pics of your genesis conversion, it seems to be interesting and what is your configuration ? For the batteries, it's not finished yet....

It was supposed to run bk12xl motor & bk12020 esc with two 3s2p maxamp lipos in series, if you meant that..
I got it running though, but with very poor success :P, the pinion got stripped pretty fast.
The boat motor mount (what I used) arent the best way to mount the motor in a car, that I have learned :D, its nearly impossible to get the right gear mesh between the spurs and pinion.

http://img201.imageshack.us/img201/9...800x600qt6.jpg
http://img227.imageshack.us/img227/5...800x600ok7.jpg
http://img201.imageshack.us/img201/9...800x600vv6.jpg
Hello, some pics of my nemesis's chassis, it's not finished yet
a++

Nice work! That is one HUGE motor..

Is the front shaft laying flat or is it at an angle? the cross-pins don't seem to be in line? (looks can be deceiving) an angle might hurt your drivetrain from the inconstant load.

Thats alot of work man! I thought you were allmost finished at the previous page :D
I know genesis/nemesis isnt easy to convert, its like any part wont go there without modding.. Even its a big car there isnt just enough room in there.

Keep it going! That will be a very nice car. Btw have you calculated the speeds on that setup?

Thanks Serum... :)

New Project is a 3080 going into that GST....

Gone.. I like what you did dude... looks really awesome... A lot cleaner than mine that's for sure... That motor just looks awesome in there, I could barely fit a 2280 into mine.. So fresh and so clean... Great Work....!!

Now THAT is what I call a TVP chassis! :mdr:

Gone, is that plastic that is sandwiched between 2 plates of aluminum?... My friend had some of that, but I don't know where he bought it.. his brother in-law gave him some... Where'd you get it from?.. those makes awesome battery trays...

The chassis isn't finished yet, it will be made in 6061 aluminum, it's only a prototype. The aluminum with plastic between the two plates is called "alucobon" and it comes from here
http://www.timcomposites.fr/produits-alucobond.asp
I don't know if you can find it in the United states
Thanks for your comments a++

http://img238.imageshack.us/img238/9...800x600vf5.jpg
An other pics a++

Thanks dude.... ... Can't wait to see a video..

http://img365.imageshack.us/img365/4...800x600ky2.jpg
http://img99.imageshack.us/img99/871...800x600fk3.jpg
http://img232.imageshack.us/img232/4...600x800hu4.jpg
The finished chassis :yipi::party:
thanks you a++

OMGOMGOMG, Thats sick! Is that motor mount a little bit twisted or is it just a camera angle?
Make sure you do a video about this beast!