thats impressive of castle!!!

Do you think they would do that with an out of warrenty MMM? obviously there would be there usual charge... but i dont mind that... i may have to ask patrick if that is something they can do...

What do you think on using a bec pro for the servo and fan's? Should I do that or is the V2 XL bec holding up?

Thanks.

I decided not to use the on-board BEC and run a separate LifePO4 pack and my ESC has been flawless.

That's what I was thinking too, I have a 2s Life from when it was gas. So when you remove the red wire just leave the pin intact but insulated so you can still connect it to Castle link correct?

I actually use a very 4" extension and take the red wire out of that so I can just unplug the ESC side and plug it into the link. That way the ESC wires are all always intact.

Ok sounds good.

I use Bec pro with castle quick connect.
This way esc wire is never unpluged from receiver as CQC is got separet wire that u plug to Castle link! Very easy to use.
Red wire from ESC u leave it, but u unplug red wire on the quick connect and viola.

http://www.rc-monster.com/forum/atta...1&d=1309696242