![]() |
Final truck update - M2C front and rear blocks.
I use M2C blocks on my buggy and they allow the suspension to move super free and make diff maintenance much easier. http://img.rcx.cz/5700.jpg http://img.rcx.cz/5800.jpg |
I need to order the same. Unfortunetly, they are out of the front kit so waiting on that...
Seems like a solid setup. |
I wasnt sure if i should go 5s or 6s with a 1700kv motor. How do you find your power? Got any videos? Is 5s enough? Thinking about going 5000 5s or 5000 6s. both will be 40c.
|
Hey Jeff, I'm running a 1550KV in my buggy on 5S, and it is plennnty but very smooth and controllable.
I would go with a 1350kv and 6s in a truggy or 1550 and 5S. |
Quote:
|
I run 3300mah G3 hyperions and they are more than OK. 5S is about right for 1700kv. very fast but controllable.
|
Of course everything but the batts are on b.o. Grrrr!!!!!
So. This motor with the MMM and a 6s I will be set. Thanks guys, sorry for the thread hijack. |
Quote:
|
That's the motor Jeff, see ya at the DORC track...
|
Quote:
|
about 13-14 minutes depending on track. we run 10minute mains so no need for heavier battery and VX G3 hyperions are able to push enough amps even from low capacity battery
|
Quote:
So the M2C ones perform better than the stock MBX6T ones? |
|
M2c toe blocks fit both buggy and truggy.
did some testing during today's race and Proline bulldog body gives bit more corner speed compared to jconcepts punisher |
few pictures from the race
http://img.rcx.cz/jel1.jpg http://img.rcx.cz/jel3.jpg http://img.rcx.cz/jel4.jpg http://img.rcx.cz/jel5.jpg |
| All times are GMT -4. The time now is 04:44 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.