1st and 2nd runs = Disaster
 

Last weekend i finally got to take my gmaxx out. After about 5 minutes or so I saw smoke coming from the truck. I ran over and took the lid off. Here come to find that I almost completley melted through my spur gear. The slipper was too loose.

On Saturday I was was able to replace the spur gear and tightened the slipper all the way. The truck was fine then. So I was driving around the backyard taking it easy trying to get used to driving the maxx. I drives so different than my pede and rusty. I makes very wide turns. I dont know if that normal or if I have to make some adjustments. So anyway I was getting bored driving so cauction so I started getting trigger happy. Well it wasnt long after that I wrecked. I slammed into a treated 4x4 fence post that was cemented into the ground. Something had to give and it wasnt the post. Needles to say I have to rebuild work to do now.

Here is the damage done.

Snapped a RD Logic CVD
Bent the Upper Arm (Look kins of like a L)
Ripped the pillow ball right out of my RPM steering Block
Unglued all 4 tires from my rims.

Luckily I have the new version of the G# upper arms I havent put on yet. I hope that the RPM steering block is still useable. I will just have to get a new CVD and check out my steering bellcrank. I recently installed the Proline servo saver and am running the Hitec 645MG.

I will see about getting some pics of the damage.

:W:

Ouch.... - Man that blows hard - Your maxx was one of the nicest ones i've seen in a long while.... Those poles dont move at all do they ...

You need more ROOM for that truck!!

Got the truck 'online' again?

No not yet. I hope to get some time this week and get her fixed up. I need to adjust my steering too. It seems like its turning too wide.

Weak servo? Or somethings binding.

monster trucks do turn a lot wider than stampedes my friend had a stampede and it tured really sharp. You just have to get used to it i think. Otherwise what braaap said is probably the cause. (something binding/ weak servo)

Its not a weak servo. Its a Hitec 645MG and I took it out of my pede.

Its most likely my pillow balls. I need to loosen them up a bit.

loosen them and see if it works. The 625 aint the best servo for a MT get a stronger one like the 200oz airtronics or hiteccs new titanium gear servos peace out

servo saver
 

Hey MaxxFusion, are you using a servo saver with that servo? And if so, what kind? I've got the same servo, and even though it's got metal gears, I'd rather not destroy it!

I have the Proline servo saver. Its great for the price if you can find one.

Thanks, I'll go looking for one now.

Just so you know they have been discountinued.

Yes. That is why I said if you can find one.

Here is a used one.

I believe they can only be run on the T-MAXX and Sport-MAXX, does anyone know about this? Anyone run one on an E-MAXX, if so, I'm getting one of these.

I believe on the stock emaxx chassis you will have to hack off the plastic stand offs. Its been a while since I had a stock chassis.