RC-Monster Heat Sink Clamp
 

Hi guys.....

What size & thread are the screws that hold the clamp end?

M3's

Newbie here... what's that mean?:oops:

And I need suggestions where to buy longer ones...

they are a metric size

They're metric 3mm flat heads. You can pick them up just about anywhere that sells screws. Here's a place I've ordered from before:

http://www.hexcrews.com/index.asp?Pa...TS&Category=16

Or, if you can figure out what length you need, one of us may have some we can send you for a buck to save you from having to buy a few and pay a boatload on shipping.

you could google metric size fasteners

M3 x 8 to be exact

that has happened to me, I bought a box of fasteners on line and paid as much for shipping as I did for the actual fasteners but considering the price of gas and my trouble I was willing

You're wanting to get longer screws to put an L clamp on a CL motor, right? IIRC, 3 x 20mm will work for that.

Thanks Guys!:party:

I need to fit the L heat sink on a 9xl motor.

M3x8....http://www.impaktrc.com/product_info...roducts_id=687

M3x20....http://www.impaktrc.com/product_info...oducts_id=1265

Perfect!! Thanks!!!

The LHS should have those:yipi:

good luck with that...the past 4-5 trips I have gone to 2 different LHSs they never have what I wanted ...I have since given up..the web is my friend

There's a HobbyTown not too far away, they have a wall full of Traxxas parts... not everything, but quite abit. We shall see tomorrow:yes:

But yea.. the web has everything:lol:

Hobbytown is one of the stores in question......:diablo:

Yeah... they didn't have those specific screws but found some there that work:yipi: