Pay It Forward!
 

This is an honor based system but these are the ground rules...

- No asking for stuff
- You have to post up something if you take something
- Taker pays shipping unless offered by giver
- Take only what you need
- No reselling - If item is no longer required re-PIF
- Smile :yipi:

All I have to PIF is a set of electric rustler front wheels/tires.

I have a HItec Aggressor 2ch AM transmitter and Futaba AM rx.

Ok, here's some more goodies that need to go:

6 Foam inserts, I believe 4 are from Losi Rock Claws and I have no idea where the other 2 are from, but they are from 2.2's

http://skellyo.com/fs/pif_foams.jpg



CVD's for an Associated T3

http://skellyo.com/fs/pif_t3cvd.jpg


Gear Cover for Traxxas Stampede/Slash/Bandit/Rustler

http://skellyo.com/fs/pif_trxcover.jpg


Turnbuckles for Traxxas VXL Rustler (I believe)

http://skellyo.com/fs/pif_turnbuckles.jpg

Got some GP3300 7cell Nihms if any could use them. They look like crap but I really wasn't into making packs that looked good. Just needed to fit. They haven't been used in a long time in a rc. I have cycled them on the charger every month or month and half. The last reading after they cycles seemed promissing. I've found they tend to not last long for a few runs but start getting thier legs back after they are used and charged a couple times. They were still great pack when I put them on the shelf after going lipo.

http://i212.photobucket.com/albums/c.../7cellp123.jpg

You can see the voltage readings of them in this link. If it would help any I can take a picture that would show them from a much greater distance.

http://s212.photobucket.com/albums/c...ade/?start=all

Heres some RPM shock towers, front, rear, and center skid plates for the 3906 e-maxx. The shock towers were dyed Black Plum. There also is a small center skid plate made from CF that protects the tranny.

http://i212.photobucket.com/albums/c...andtowers1.jpg


Some small losi 2.2 tires (only 2 of them)

http://i212.photobucket.com/albums/c...si22pins1a.jpg

and a VXL differential that is filled with jb weld for that spool effect.

http://i212.photobucket.com/albums/c...lockeddiff.jpg

also have 4 GP3300 6 cell packs. Not sure on the condition.

I have Lots of Duratrax evader parts- trans is toasted... Needs too shocks.. no wheels and tires

I have a set or rustler wheels and tires off a xl5.

I have these. (40 series only)

Memory sticks - came out of a Dell Optiplex GX620 X86-based PC

Samsung
(2) 256MB 1Rx16 PC2-4200U-444-12-C3
(1) 256MB 1Rx16 PC2-4200U-444-12-C1
(1) 512MB 1Rx8 PC2-4200U-444-12-D3

i have 2 sets of 20mm hub adapters for a savage, i have no need for them, 20mm is the 420 sized rim from losi, like on the muggy

also still have 3 /genesis/nemesis/gst tires just need busted up rims removed.

i have an old astro flight ac/dc charger charges up to to 8 cells and up to 7amps,
pm for pics and details

I've some used badlands - Gone

stock old emaxx tires - available

Hyper 7 - lower F arms

I have lots of spare parts for a hyper 7, or similar fitting buggy. an Rx pack or 2.

PM with what you need

I have a bunch of radio shack 3300 cells if any one wants them....not in the best condition, but they hold a charge

Some truggy tires + wheels. 3.2" dish wheels with negative offset, and Medial PRO sportline tires. Lightly used, with 17mm adapters for 7mm axles. Pics here: www.troy-vision.com

If you want to pay for shipping from FL. U.S. I have a used/like new REVO 3.3 chassis if you want it ? There is a slot dremeled in it for a vercro battery strap to pass through other than that it's new with some dirt.

7.2v Battery and Charger for a dremel
 

7.2v Battery and Charger for a dremel. Was given to me sometime ago but I never had a dremel that took that battery style. Battery pack has # 757-01 on it. Pay the postage and it yours.

http://i212.photobucket.com/albums/c...remelbatt2.jpg

http://i212.photobucket.com/albums/c...dremelbatt.jpg

Will go to first PM received.

Few things that I haven't been able to sell, pay the postage and possibly cost of a box and they are yours:
http://img38.imagefra.me/img/img38/2...hm_6ce4fcc.jpg
http://img37.imagefra.me/img/img37/2...hm_be6dc4e.jpghttp://img40.imagefra.me/img/img40/2...jm_b54d852.jpg

Just wanted to add some stuff and say that the Castle Links are both gone. This is also posted locally for free. I will give these items till Friday March 26th than they go in the trash, or recycling bin.
http://img37.imagefra.me/img/img37/2...cm_76e2e1f.jpg
http://img38.imagefra.me/img/img38/2...dm_5cb93df.jpghttp://img40.imagefra.me/img/img40/2...fm_103375d.jpg
http://img40.imagefra.me/img/img40/2...gm_b5a1cdb.jpg

Axial 40-series wheels, never used or glued, 17mm hub. I no longer have any MT's so someone can have these for free, just pay shipping.

http://i47.photobucket.com/albums/f1...3/P1020588.jpg

Dibs on the Axial wheels...what's shipping to 35901?

Mods can you delete my section, all of it has been passed on. Delete this post as well please. Thanks!

Here is my submission...

A set of brand-new wheels and tires that will fit the front & rear of the RC18 series, the rear of the Mini-T series, and any other vehicle that uses cross-pin mounted wheels.

They are free, except for the price of the actual shipping method of your choice.

http://pics.offroadextremes.com/rc/t100_tires.jpg

I have a coupon for the free CastleLink or $10 FieldLink that came with my MMP that someone can have. I'll even send it for free since it only costs a stamp. Or I can just PM you the code.

For some reason the code says it's invalid when I tried to enter it on the Castle shopping cart system, but I have heard of this happening before, and I am sure if you email Castle they can sort it out. It is definitely a valid and unused code.

What is this FieldLink thing? I have the CastleLink for the PC, but if the FieldLink is lke a programming card, I definitely want it! I am not always near a computer, and I refuse to bring my Laptopto dusty/dirty places.

Edit: Ahhh, I looked it up, I definitely want it...it is awesome!

http://www.castlecreations.com/image...button-car.jpg

I bought the xxx main video TRUCK_x2 "resurgence". It's their latest monster truck vid. It's alright. Pay shipping and it's yours, pm me:intello:

Anyone happen to have a set of 27.xxx crystals? :D

you can flip the RX/TX crystals and get another channel:wink:

Whatcha mean? I broke the rx crystal is why i need a new set.

And no you can't flip them, there is one meant for the tx and one for the rx iirc but I know that even if that wasn't the case youy couldn't just flip them around and have a different channel.

Bringing this out of the depths!

I have a box of random rc parts. Most are for planes, but I have one or two parts for cars/trucks. This is good quality stuff that is actually worth quite a pretty penny. I'm getting rid of it since I'm 90% out of the rc scene as of right now, and I don't feel like selling it. This was always my favorite rc site, so I'm giving up the goods to you guys.

Now, I'd like to minimize my shipping costs and give this all to one person, so here is my request:
** Who ever picks this up can cherry pick what they want, and then I ask you post the remaining stuff back on this thread for someone else to have. Please do not re-sell it for profit. I also ask you to keep with the spirit of this thread and include something of yours as well. **

Thanks for your time and here are the items:

- Brand new Yutong 3s 3200mah lipo
- Dualsky 3s 1300mah 25c lipo
- Dualsky 3s 1700mah 17c lipo
- Rhino 2s 360mah lipo
- 3x Brand new 2DogsRc 2gram Micro outrunners (great for kyosho minium or parkzone micro planes)
- Duratrax Vendetta on-road front bumper
- Duratrax ICE temp guage
- Random outrunner flight pack (for use with the rhino 2s 360mah lipo)
- Xray Xb8 wing mount (one mount is gone)

http://i888.photobucket.com/albums/a...5/DSC00580.jpg

I never thought it would take so long to give something away....

Taken by Brushlessboy16

I've got an EnerG 4200 mAh 7 and 6 cell NiMH battery packs from pro-match batteries I could give away. They will come with leads, but no plugs. They are in rough shape. 7 cell has been fixed once or twice, 6 cell is still truckin I think.
Not sure how long they last or how well they work anymore, were pretty dang good NiMHs back in the day. Some people thought the 7 cell was a lipo when I first started.

To clarify there are 2 batts.
I'll split em up or send em together, your choice. I would require paypal sent to me as gift for 5.20 to USA and more for internation (around 11-13$)

I'll just toss em in the trash here at the end of the week anyway. hope someone can get a little more use outta them.

Pictures can be given upon request, gf is gone with the camera right now.

first to PM me gets em, don't have to post here.

I just got a new soldering iron, so if someone wants my old one they can have it. It's a Weller WLC100 (40W). It's in somewhat rough shape, but still works fine. Tip should be replaced. Could probably clean up the barrel a bit with a wire brush.

PM me if interested, you pay for shipping method of your choice.

http://i47.photobucket.com/albums/f1...3/P1020836.jpg

http://i47.photobucket.com/albums/f1...3/P1020837.jpg