Fitment problem
 

Hey guys im trying to find a suitable mod1 spur for my warhead, the input to the trans is 6mm.
i was looking at the nitro savage spur which has an hole ID of 5mm. a 15/64 drill bit is 5.95 so i was going to try to drill it out..



Does anyone know of a 50-54t mod1 spur that uses a 6mm hole?

any way to get around this problem?

Have you looked at the MGT 52T spur? I 'm not sure of the hole ID though.

hm, i will but i don tknow if the slipper design wiould work with the esavage plates

the mgt spur wont work but the 8.0 happens to have a 6mm shaft and a 49t steel spur, i think i might go with that ;D thanks george