2 MMM all running well
 

I got back all my MMM v2 and tested and ran them both one in my truggy with neu 1515 2.5D put 4,5 and 6 s lipos without any problems a blast to drive in 6s lipos beating any 1/8 nitro buggies in the oval race.the other one i put it in my losi xxxt stadium running it with 4s lipos never seen a stadium truck runs that fast, it was running in topspeed all of a sudden it lifts and did a cartwheel and broke my steering servo, but still turns to the right,so i ran it again this time then it melted the tranny :surprised::surprised: So I can say that I 'm lucky to have 2 MMMs v.2 working so far

very lucky.....:lol:on 4 unit only one survive for me!!!:party:

wait man!!:oh:

are you running an external BEC or the MMM bec ??....
i'm in the build process of a CRT conversion using the same exact set up your running....keeping my fingers crossed that my MMM will work ...LOL....i'll search to see if you have a build thread or pics on here ....

I dropped a MMM v2 in my 8ight buggy conversion (medusa v2 2000) and I've run about 4 4s packs through it w/o any hiccups yet. knock on wood ;P I'm running the tekno v3 setup so mechanical brakes, and reverse lockout, and I am using the internal BEC.

A xxx-t with a 4s lipos is great. I did it with a lehner basic 4200 geared 18/84, and a 4s 3700 lipo in a xxx-t mf2. It had to be over 100mph but ddint have a radar gun. After trying it again after I recharged the battery I killed the motor. The magnet separated from the shaft.

Glad to hear you got a few good ones. I hope when I get mine my luck is as good as yours

Both of my MMM V2s have 4 packs each and no problems at all.1 with 4s Neu 1515/1.5d and another 4s Neu 1512/1.5d.

No modifications running with internal BEC no rx pack , I did it with my version 1 MMM running an external rx pack before but eventually died

LOL mine just running at full speed then all of a sudden lifted then cart wheeled needs to work on aerodynamics of the truck but what an experience

scratch that... another v2 mmm bites the dust.. packaged and ready to ship back to Castle. Right about now I'm thinking castle owes me something special.. this is retarded. I have somewhere between 35 and 40 tied up in shipping.. not to mention the extra hassle (my time) and gas to get down to the post office. Arrgghhh Sorry hadda vent a bit :)

This one was running great.. about 20-30minutes of use.. did a little hiccup or two then just died.. nothing wouldn't power up no matter what I did.

8ight Buggy conversion (tekno kit) using mechanical brakes and foward only
Medusa v2 2000kv (60mm)
15t/48t
dx3r
Polyquest (enerland) 30c 4s lipo

yAy

you run a Neu in a stadium truck? would this work with a Rustler VXL? i have a 1515 1.5D/F and a 1512 1.5D/F. one is in my buggy but i would love to throw one in the Rustler and watch it fly. any ideas if this is possible? if not i am planning on building a CRT .5 BL and a Losi 8T BL and using the xtra motor for one of those.