Center driveshafts for my crt.5
 

I am building a custom chassis for my crt.5....1" longer than Mike's 40mm chassis and need longer center drive shafts. Other than having custom ones made, where could I look for ones...

The ones I have are 76mm pin to pin...overall length is 82.5mm

I need roughly 94-95mm overall length

I found these...would they work? They are 96mm long...I think that they would work, but not sure. When they measure these, do they measure pin to pin or overall length?

http://www3.towerhobbies.com/cgi-bin...?&I=LXLVT1&P=7

The crt.5 uses small drive shafts(small diameter balls and relatively thin shafts - a 1/8 buggy shaft won't fit the drive cups).

Looking at them again, I figured as much....thanks Mike!