Hybrid Diff Outdrive
 

Hey guys, with the hybrid diffs, I will need to order these to attach to the pinion to work with the CVD's in my G2R, correct?

http://www.rc-monster.com/proddetail...rivecup&cat=40

for the center cvd yes you need 8mm cup but for the right and left cvd you need 6mm cup.

be aware you will find problem with rear and front cvd's its to short so read this post http://www.rc-monster.com/forum/showthread.php?p=272146

that cup is for the centre cvd shaft...

The new v3 diffs don't use an 8mm drive cup on the diff pinion - the drive cup is now included, actually. :)
The V3 diffs are smaller than their predecessors and actually uses a different diff altogether(smaller size than the larger Ofna/Hot Bodies size used previously) - the pinion is actually 5mm at the drive cup area on the new hybrids(similar to Mugen diffs).

So Mike, what diffs. will work then w/the v3...so you are saying that Mugen diffs will work? I was hoping against all hope that my HB diffs would fit...:smile:

I figured it out!

I just ordered a pair of the V3's. Will let you guys know how it all goes when they come in. (Obviously, it'll probably be me just ranting about how great they are. :mdr: )

I also just ordered...only one...I have to wait until paypal funds clear!

Mugen, AE, XRay and Losi diffs should all fit the new case - haven't tried any of these so try at your own risk, but the new diffs are similar in size to the above mentioned diffs. :)

mike any eta on shipping?

Shipping tomorrow - The Post office is closed right now. :)

Check your email, Chris. :)

I really don't often hear of Mike not shipping next day if the parts are in stock...