.5 Front Center Dog Bone Part Number?
 

Anybody have the part number for the front center dogbone for the .5 with the extended chassis? I believe its 60mm but can find a part number to get one.

I believe its MIA0000

IOW, I have no freaking clue and Jammin is/was slow as hell putting one out as a single part. Thank god I never bent one..

http://www3.towerhobbies.com/cgi-bin...&I=LXBTA8&P=FR

Anybody know if this one will work? It says its 60mm with a 3.2mm diatmeter. Is that the small ones or the larger 1/8th scale size stuff?

Is that the Jammin extended chassis or the RC-M chassis? With the RC-M chassis it's the same length as the rear shaft CLICK.

Its the Jammin chassis.

IDK, I know there was a thread here a little while ago where someone else was looking for the dogbone. I thought that that was not quite a fit, but I don't remem exactly. Search maybe?

I searched and didnt come up with anything.

DANG I just bent a rear one. It might have been me looking for dogbones when I had my outrunner setup... Blew both hpi dogbones! :lol: I went to an inrunner setup.

Stupid me, after a ginormous jump over a trailer at full speed my gear mesh was off. I unbolted the center diff assembly to adjust the dang mesh. I think when I tossed it on the ground with the center diff assebly loose, it bent the rear shaft. DANG. I need new ones too, and I can't find any.

Hey! I've got the manual for the RTR, although I think I have the PRO version. (chassis is exactly 12" long if anyone can confirm this; my chassis fits a standard servo) The front dogbone is listed as just 40920, and so is the rear one. They must come in a pack of two.

The manual says as follows:

40920 CENTER DRIVE SHAFTS, 60/82.5mm [retail] $15.95

The mesurements seem right after trying to bend the rear one back.

Found them here, about 1/4 way down - http://www.ofna.com/parts.php?start=3600

But nowhere else.

I'll shoot OFNA an email, along with my lhs

Thanks for the part number that helps a ton. Now to just find some online or see if my lha can get them. Thanks man.

Let me know where you end up finding them. I need a set too...

I found a couple sites with them listed last nite but im not sure if they have them in stock. I snet them a email to see which had them. Ill let you know.

Nitro house may have them - I have some spares at home that I might not need as have RCM chassis.

Post up the size when you know what you need.

I sent them a email to see if they had them in stock.

Let me know if you have any. That would be great. The one I need is 60mm. I will also take a extra rear one if you have one. It is 82.5mm.

Just let me know man. Thanks.

Hey Metallover these 2 places said they had them in stock.

http://www.nitrohouse.com/catalog/ad...cc1cd0022dadf3

http://www.rcmallonline.com/advanced...keywords=40920