hpi savage low center of gravity chassis
 

does anyone know about using hpi savage low center of gravity chassis .i own an hpi savage limited edition and wanted to purchase one of these L.C.of G. chassisies but then i was reading somewhere that the roto start system wasent compatible with it .does anybody know if this is true or any other problems i might run into.also if that is true how does savage x get away with roto start system do you know if i could buy a savage x chassis and put all of my stuff off my limited edition on it without very much modification .please help tired of roll overs beating up and breaking my bodies
t.y.
badoff:007: :002:

There are a few around the forum that runs the cog chassis. I think most are brushless though. I have asked about the chassis to but use pull start. I don't know about the roto start.

badoff you wont have any problems if you convert to brushless

i would use the flm extended lowered tvps. im not positive but it should still work with the rotostart.

Yeah, go with the FLM stuff for sure. I got the extended plates and am very happy with them!

Cheaper and tougher!