What happened to my MM?
 

i was fixing my Mamba max to my 1/8 ep buggy. fixed a bec for it. Started & worked. But when i connected to my laptop it tried to update the software but I cancel it when it took too long.

After that the esc just cant work any more, servo & rx worked but no light or sound on the MM.

I moved the switch thought it maybe loose but still nothing. There was a dim red light on the esc when I switch on. But still cant work.

Is it a corrupted software in the esc? The laptop can still detect the esc but cant update or set it default.

any idea what went wrong or its damaged & need to send for repair?

Any master reset I can do manually on the esc? Thx guys!

Try to see if you can update the firmware.

How did you connect the esc to the laptop- via a castle link or with the usb cable?

Tried with updated software & old software. Tried both USB & castlelink. All can't work.

Old software can detect but can no longer update or set the esc to default.

What went wrong?

bypass the switch altogether

Meh, sounds like its done for..

I dun think it's the switch since even the computer can't update it. Do we did to switch on to update via USB?

How do I trade in for a mm pro? I don't see any forms in castle website

I went to castle website only found non warranty repair at $50 no $79? Where do I go to print the correct form?

Patrick said you need to include a note on the form to ask for an upgrade to the MMpro- its not an official thing yet, and you will join the end of the queue since MMpros are in short supply (specifically the FETs). Its $75(?) to upgrade to the MMPro, otherwise if the esc is less than 12months old and no rewiring has taken place on the esc itself, standard warrenty replacement/repair will be free (+ shipping).