RPM Skidplate now for Flux!
 

Woooo, all the emails and suggestions to RPM from everyone who has been wanting this has paid off at long last! RPM has just announced the release of a dedicated RPM skid plate for our Savage Flux!!


http://www.rpmrcproducts.com/product...s.htm#fluxskid



http://www.rpmrcproducts.com/product...ires/73352.jpg


http://www.rpmrcproducts.com/product...s/73352Ins.jpg

Well that didn't take long. Place your bets for a decent belted MT tire.

Least it looks like you can remove it by undoing only 2 screws.

Err I see 4.

Was thinking that the end with the screws that are close together just slides in.

Long enough... now how long until they make an XL skidplate and an Flux XL skidplate?

Looks like the front two are just holding blocks that clip into the tvps. The others are holding a tab. You may not need any screws to undo to get it out. Pop the clips and slid the tabbed end out.

Wow that's fast, almost 2 years after the launch...

Tons of people are switching to XL, so I'm guessing in another 2 years we will have RPM XL center skid plates.

lol. I think it was Freeze's emails that put it over the top