mamba monster +250cº .... I dont understand :(
 

see to believe ......

I had much luck because the lipo survived at this disaster .... turnigy nano tech 4s 45-90c

http://i622.photobucket.com/albums/t...h/S1390001.jpg
http://i622.photobucket.com/albums/t...h/S1390002.jpg
http://i622.photobucket.com/albums/t...h/S1390003.jpg
http://i622.photobucket.com/albums/t...h/S1390005.jpg

What was this MMM in? vehicle, weight, gearing, ect...

1/8tt, 3.8kg rtr, 4s lipo, 15t pinion etc etc

Just curious... is that a stone i see wedged between the fan and the heatsynk in the first photo?... if that's the case, the fan didn't get to do it's job then... Just have a closer look to see if that's the issue....


Alien

it would have thermaled without the fan before it melted itself.....
If the fan was on there to keep it from melting, then that would be a crazy setup.

Check your motor....

the stone was in this place much time ....... and the fan work perfect all the time (I check in all my runs because I had many problems with the castle fans :( )

all the time the esc was 30-40cº max ..... we measured many times with the same motor .......... but in the last battery the esc smoken brutality and arrive at +220cº ........... the motor is perfect, after this destroy I used the same motor in my other mmm and I dont had any problem

the motor is perfect, after this destroy I used the same motor in my other mmm and I dont had any problem

I had 6 mmm and is the first time I saw this disaster :surprised: :whip: