|
My maxx
1 Attachment(s)
it's my tmaxx now brushless
|
2 VX G3 5400mah 2s MM2200KV XTM big block chassis 3906 trany locked in 2nd ue 8 diffs ue shocks mip cvds rpm arms & RPM Axle Carriers ue rear dog bone ofna dom front dog bone hc titanium skid
|
Got more pics from different angles?
|
Yep
Quote:
|
1 Attachment(s)
back flip
|
pics
3 Attachment(s)
pics
|
3 Attachment(s)
next mod is lst2 axles proline 23mm hex rpm revo carries
|
Looks sexy lol. What size carrier bearings (both, inner outer) did you use with lst driveshafts?
|
I was gonna ask the same thing- every guys that has done the LST cvd upgrade has had to run odd-sized bearing or shim them to make them fit correctly- did you have to do anything special as such?
|
big hole is 24.5mm I used two 15x24 and alum tape. small end is 15mm now 5/8 so 16x8mm fits good and tight I'll try to post some better pic of how I did it later
|
Did you have to drill new holes in the axles? Nice truck BTW.
|
thanks Kcz25 looks like I can run it with some shims (3mm) or small spacer or drill new hole still in the works
|
nylon washers 5/16
3 Attachment(s)
nylon washers 5/16 + 1 8mm shim
|
pics
3 Attachment(s)
got the washers fror hardwear store
|
painted my cage and fixed some bad welds
3 Attachment(s)
and put lst 2 axles on the back hard to see but it's an inch wider in the rear
|
| All times are GMT -4. The time now is 11:25 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.