brushless lst my way
 

hello.

after i saw hundreds of conversions of this big and awesome truck i decide to did it on mine and don´t like the final speed and handling with stock nitro transmission.

so i decide to go ahead and this is final product right now:

http://imageshack.us/a/img19/2526/tr0j.jpg

http://imageshack.us/a/img24/4089/cqzs.jpg

http://imageshack.us/a/img823/9075/oy6c.jpg

http://imageshack.us/a/img9/9933/98d2.jpg

http://imageshack.us/a/img43/6360/ow46.jpg

http://imageshack.us/a/img18/283/sh3l.jpg

i use a e-maxx brushless transmission over a 2.5 carbon plate to acomodate transmission to stock nitro chassis on a position that i was able to balance space between stock center driveshafts.
i also buy 17 mms wheel hubs and front/rear sawy bars.
is a all diferente truck and rtr weight is 4,7 kilos(10.3 pounds) with lipo and body and truggy wheels.
this is xxl front and rear end on shorter wheelbase lst2 chassis.

with this weight reduction the truck handle like a dream and very neutral and balanced!!

hope you guys enjoy!

greetings from Portugal!!

Great work
 

I did the same using a summit trans a few months ago
it works wonderful but you are going to have to upgrade the slipper.
http://www.rc-monster.com/forum/showthread.php?t=31790

i already done it. i use a mod1 monster gt old model slipper and is great because is 49t and gives better final ratio to the motor!!

i saw your bulid earlier too and great project too!!

greetings