Braided fuel line over my wires
 

O.K. I've seen a few people conceal there wires on the e-maxx by using the braided line that is norally use for the fuel lines.

I mentioned this at the lhs and got very negative feedback.
Bad conductors and heat or something somethin.

I figure you guys would know the pro's and con's
So please help me out thanks.

Anyone?

Yeah that sounds interesting. I dont see that on any rustlers or stampedes. I will have to try it. I understand: "bad conductors" you wont be using it for your wires would you? If anything I would try to get a fuel line that is not conductive so it can short out something if there is a cut in the wires.

No just to cover them.

If you just cover the wire and then use some heat shrink at the end - i cant see how that would cause a problem imho...

Where can you get that braiding?

A certain someone I know sells some *wink* *wink* lol

I ended up using the plastic coil stuff
http://www.rcbros.com/projects/Theunknown/close2.jpg

Ebay has lots of it!

Yes ebay too. I tried Jerry's and they don't sell it. Then I went to napa and shucks and they didn't have any either

i would use that plastic stuff