bolido question
 

what cells should i run with the motor. not looking at running with lipos right now. i cannot tell you guys what it is going in either. if you need to know PM me

What's the KV?

You have a controller that could run it?

If I'm not mistaken, the Bolido has a 10mm shaft! That might be a problem...

I think it is a 8 or 10 pole motor as well. So rpm is going to be limited.

It's a 10 poler.

I found this on another site:

for 24-30 cells, recommended controller: Future 40.160 WK, for 1:5 scale, 9HP!

-Rob

that is the one i was going to use :D

Too bad you don't want to go Lehner.. their 3080 is good for 15 hp..

the 3040 does about the same as the bolido, but requires a less expensive controller. And if you where willing to share what project it would be on, we might as well advice you on the controller. Perhaps the Phoenix HV110 would be good for the project.

I think I would pic the lehner 30 80 or 3060 for it is a 2 pole and can carry a higher rpm limit. not that you will need it.

yeah you are right. that is exactlly what i changed my min towards at this point. i am going to send you a PM

PM received and answered!

the 2280/ 3040 would be the motor of my choice.

Powerhungry boy... :p

Serum, I already suggested the 30 Series and a HV110 yesterday :p.

the HV110 doesn't seem to be a good option. check Startscreams last reply

Yea. Just read it. Doesn't seem to be very promising :frown:...