Is there any new motors
 

I was planning on purchasing my brushless motor soon(7XL) do you know if there are any new good motors comming out soon, because i dont want to buy the motor and the next week something twice as good comes out.(not like this usually happens but just to make sure). Thanks

Probably not at the Wanderer/Feigao price range. It doesn't get much better than the Neu or LMT if that's what you're looking at...

I know you cant beat the price i was just wordering in general if there was any more lehners comming out or any other motors in general i does not have to be cheap.

I think the lehner XXL's are coming out soon or are already out...:032:

Bye:018:

i havent seen them yet. I hope prices stay bellow 200 bux!

If they are xxl, i would assume they would.

To be honest...I'm thinking there gonna be $175...Figure in that the Basics are $125, the Basic XL's are $150, and I would think the Basic XXL's would be $175...

...here is the Lehner XXL but does this page say that its a 4mm axle? Does that mean its a 4mm shaft? oops...

Axle, shaft, whatever. It's the long rod thingy in the middle. :)

...Gees you guys are strict :(

...and i MEANT that its 4mm? and not 5? Like i CARE what they want to call it...gees...

I'm just giving you a hard time. :dft012:

...I just thought the 'standard' for pinion sizes was 5mm or 3.2...It was a surprise to see a motor with a FOUR mm...I would imagine that would make finding a 4mm Mod. 1 pinion a little tricky...In future i will abstain from any presumptions...I obviously dont have the post count to be taken seriously by the forum 'leaders' :(

There must be some since Mike has several 4mm Mod1 pinions with tooth counts ranging from 10T to 20T in the store. Actually, according to the BK-Electronics site, the LMT 1950 has a 4mm shaft.

By the way, I wasn't trying to be mean or anything. I thought you were poking fun at the terminology when you said "that its a 4mm axle? Does that mean its a 4mm shaft? oops...". I apologize for the misunderstanding.

EDIT: And I'm not one of the forum leaders, regardless of post count...

...well then dont i just look silly...I was unaware of the 4mm option...but someone has to wear the noob hat now dont they...Apologies...I will crawl back into my corner now and re-arrange my sock drawer...

Define soon..

CastleCreations is coming with a new controller/motor.. :p