|
savage conversion and battery position!!!!!
hi.. i'm triyng to modify my BL savage, and i'm looking a place where put my 6 cell Nimh packs.. or maybe a better situation.. please post me your position...
have u some photos to post me? looking for new idea.. :032: :032: use also some lipo, but for the weal of this battery type i'm thinking to use nimH in hard situation.. (just burn 2 lipo pack :035: :035: ) thank u guys!!!!!:028: |
Depends on location of motor. I have seen some stick them inside the chassis
where the nitro motor was. Some get the koyosh battery holders and mount them to the outside of chassis. I made a bottom plate for mine and mounted them really low. It also acted as a skid plate to. |
|
The sides are you best bet. I would check into some koyosho battery holders.
Then you can mount them on sides with a few spacers if had to. What spur gear is that. That don't look like a savage one. |
nafta - nice savage!!:004:
|
thank u guys.... :028:
can i have a link where find this kyosho holder?? but i think that lipo are too weak to be placed in the side.. too many rocks, land, water could be damage they... :013: :013: spurs it's a 72t 32p by an emaxx... like the tranny... |
|
up date...
thank u Danverz to gift me the rc monster sticker (how can i buy some sheets??):004: :004: http://img.photobucket.com/albums/v6...t/S6000141.jpg http://img.photobucket.com/albums/v6...t/S6000138.jpg http://img.photobucket.com/albums/v6...t/S6000137.jpg http://img.photobucket.com/albums/v6...t/S6000136.jpg |
Lookin' good.:028:
|
Get an aluminum U-profile and make something yourself. with velcro and some foam you have got a good setup.
|
i know this thread is old but how is the hv-maxx holding up in the savy? does it over heat much? and is it a power house? nice savage.
|
| All times are GMT -4. The time now is 04:19 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.