spektrum problems!
 

seems like everytime i run my rc, something breaks. Now tits my spektrum. I opend up the lsp to disocover that the whole antenna was ripped off. I currenlty have about an 1 cm lenght of spektrum wire. I never expereinced glitching issues so i think i'll still use it at that, but is it possible to fix with wire from another reciever? Will i have to buy special wire?

if you are good at soldering i'd take a shot at it.
take a wire from a old rx.
or go to electrics store and get wire.
really tiny wire tough, dont know what gauge.

I did the same thing. The only problem is that the wire NEEDS to be a specific length (according to the Spektrum guys anyway). If you have another receiver, you can open that up to get a complete measurement on the length of the wire.

My LHS had replacement wire on the rack, so I just got some and opened up my receiver. The spot that you have to solder to is right there on top. I used a very small chisel tip at about 600 degrees and knocked it out in no time. I did this about a year and a half ago, and haven't had any issues.

Just a note though. Doing this WILL void the warranty. If yours is under warranty, you might want to just send it in and play the waiting game. Also...IIRC, the pcb has a sealant applied to it. I just scraped this from the solder joint with an Xacto knife. If the sealant is there, you have to remove it, as you can't solder through it.

does it matter what wire? could i jsut use wire from a fm or am reciever?