RC-Monster Forums - View Single Post

BrianG · 04.28.2007, 08:41 PM

Welcome to the forums!

You'll have to modify the chassis tranny hole a tad with a dremel or file. Go slowly taking just a tiny bit off at a time test-fitting the tranny every few minutes. Then, the mounting holes in the chassis will have to be elongated a little to match up with the E tranny.

To lock in second, you can either do a homemade job where you screw the dog carrier into second gear, or get the gmaxx locking hub:

You are most likely going to want to get the following as well:
- Steel idler
- Strobe slipper setup
- Ofna 51T spur
- Mod1 5mm bore pinions assuming you go with an XL motor. (10th item down the page).

Revo centers might fit, but they may rub a little on the Revo bulks. A little dremeling should fix that. Or, contact Mike (site owner) and see about getting custom dogbones made.

	(#2)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	04.28.2007, 08:41 PM Welcome to the forums! You'll have to modify the chassis tranny hole a tad with a dremel or file. Go slowly taking just a tiny bit off at a time test-fitting the tranny every few minutes. Then, the mounting holes in the chassis will have to be elongated a little to match up with the E tranny. To lock in second, you can either do a homemade job where you screw the dog carrier into second gear, or get the gmaxx locking hub: You are most likely going to want to get the following as well: - Steel idler - Strobe slipper setup - Ofna 51T spur - Mod1 5mm bore pinions assuming you go with an XL motor. (10th item down the page). Revo centers might fit, but they may rub a little on the Revo bulks. A little dremeling should fix that. Or, contact Mike (site owner) and see about getting custom dogbones made.