RC-Monster Forums - View Single Post

zeropointbug · 02:53 AM

They probably were talking about inductance? At higher frequencies that are present in these BL controllers, inductance must be noticed and accounted for.

Also, flat wire (or flattened copper pipe), buss bar, whatever has lower inductance, and resistance than round wire. This is because inside the wire (round), there are self induced eddy currents which turn into heat.

But no doubt your setup should perform very well, i am going to have to use the same setup for a while with the clamp thing, until I get the case machined.

	(#517)
zeropointbug Z-Pinch racer Offline Posts: 3,141 Join Date: Nov 2006 Location: SK, Canada	06.09.2007, 02:52 AM They probably were talking about inductance? At higher frequencies that are present in these BL controllers, inductance must be noticed and accounted for. Also, flat wire (or flattened copper pipe), buss bar, whatever has lower inductance, and resistance than round wire. This is because inside the wire (round), there are self induced eddy currents which turn into heat. But no doubt your setup should perform very well, i am going to have to use the same setup for a while with the clamp thing, until I get the case machined. “The modern astrophysical concept that ascribes the sun’s energy to thermonuclear reactions deep in the solar interior is contradicted by nearly every observable aspect of the sun.” —Ralph E. Juergens Last edited by zeropointbug; 06.09.2007 at 02:53 AM.