RC-Monster Forums - View Single Post

renny · **COOKED BK controller??? -** 06.23.2007, 04:49 AM

Its been a while since I was here last but if my hunch is correct then I now know were im going to purchase my new controller...RC mike

I took my E-revo for a rip and it happened to get out of range and straight over the road and into a SMALL puddle (pool) of water.

The BK controller was sealed by me with sillicone, but now it seems to surge as I roll on the gas or for that matter punch it.

The lipos are fully charged, alllllllllll the other electronics were taken out ,checked or replaced ( no sillicone OPPPPS) ,but I have no other ways to check the ESC.

When I finealy got to it,the truck was up side down in the puddle and when I strarted to check things out I noticed that there was a very LITTLE moister at the bottom of the controler but it was on the heatsink side?

Any ideas will be helpfull.

P.S.
Its feels good to be home

	(#1)
renny if you build it.... Then I can break it Offline Posts: 73 Join Date: Jan 2007 Location: albert canada	COOKED BK controller??? - 06.23.2007, 04:49 AM Its been a while since I was here last but if my hunch is correct then I now know were im going to purchase my new controller...RC mike I took my E-revo for a rip and it happened to get out of range and straight over the road and into a SMALL puddle (pool) of water. The BK controller was sealed by me with sillicone, but now it seems to surge as I roll on the gas or for that matter punch it. The lipos are fully charged, alllllllllll the other electronics were taken out ,checked or replaced ( no sillicone OPPPPS) ,but I have no other ways to check the ESC. When I finealy got to it,the truck was up side down in the puddle and when I strarted to check things out I noticed that there was a very LITTLE moister at the bottom of the controler but it was on the heatsink side? Any ideas will be helpfull. P.S. Its feels good to be home