RC-Monster Forums - View Single Post

DrKnow65 · 10.21.2007, 05:04 PM

Awesome! Now just fo find the perfect copper finned heat sinks (6mm tall, 24mm wide, and 32mm long- with the fins running along the length). What grit sand paper are you using? I do plan on using the new arctic MX-2 since the the whole esc will be held togeather by the case. Then I could open it back up and mod it more later without dealing with the thermal adhesive...

P.S. why use brass as apposed to copper? copper is a better conducter right?

I was also thinking about stacking copper tubing 2 high (like a honeycomb) and gluing them togeather with the arctic silver then MX-2 to the fet's. would that be effective or should I continue the persuit of somthing finned? Not sure of the purity of copper tubing...

	(#12)
DrKnow65 RC-Monster Aluminum Offline Posts: 998 Join Date: Oct 2007 Location: Colorado	10.21.2007, 05:04 PM Awesome! Now just fo find the perfect copper finned heat sinks (6mm tall, 24mm wide, and 32mm long- with the fins running along the length). What grit sand paper are you using? I do plan on using the new arctic MX-2 since the the whole esc will be held togeather by the case. Then I could open it back up and mod it more later without dealing with the thermal adhesive... P.S. why use brass as apposed to copper? copper is a better conducter right? I was also thinking about stacking copper tubing 2 high (like a honeycomb) and gluing them togeather with the arctic silver then MX-2 to the fet's. would that be effective or should I continue the persuit of somthing finned? Not sure of the purity of copper tubing... If I could only draw what I see in my head, then afford to build it, and finaly get to play with it...