RC-Monster Forums - View Single Post

Finnster · 11.02.2007, 01:23 PM

Be sure to leave the motor brace in back loose whenver you move the motor. Its should slide back and forth until you have the mesh set, tighten the motor screws down, then tighten the brace screws.

If you don't the motor can be a bit offset even when you think you've put the mesh back to the same place.

	(#4)
Finnster KillaHurtz Offline Posts: 2,958 Join Date: Apr 2006 Location: Bucks Co, PA	11.02.2007, 01:23 PM Be sure to leave the motor brace in back loose whenver you move the motor. Its should slide back and forth until you have the mesh set, tighten the motor screws down, then tighten the brace screws. If you don't the motor can be a bit offset even when you think you've put the mesh back to the same place.