RC-Monster Forums - View Single Post

mabu · **Quark Monster Pro 125 and Lipoly Setting -** 12.06.2007, 05:00 PM

Hi,

can somebody tell me what's the exact difference on the settings "Lipoly Normal" and "Lipoly High"?
Does the controller limit the voltage at setting "Lipoly Normal"?

I am running a Neu 1515 1y with this controller in a E-Revo converted with the teknorc conversion powered by a 4s Kokam H5 3200 lipoly. The transmission is 16/38 with wide ration.

I did a first run today and the motor began to stutter when the Revo switched into the second gear. I set up the controller at "Lipoly Normal". Is it possible that this setting causes this attitude?

Do you think it's ok/safe to use Lipoly High at this setup?

Thanks :)

	(#1)
mabu RC-Monster Carbon Fiber Offline Posts: 50 Join Date: Nov 2007 Location: Austria, Graz	Quark Monster Pro 125 and Lipoly Setting - 12.06.2007, 05:00 PM Hi, can somebody tell me what's the exact difference on the settings "Lipoly Normal" and "Lipoly High"? Does the controller limit the voltage at setting "Lipoly Normal"? I am running a Neu 1515 1y with this controller in a E-Revo converted with the teknorc conversion powered by a 4s Kokam H5 3200 lipoly. The transmission is 16/38 with wide ration. I did a first run today and the motor began to stutter when the Revo switched into the second gear. I set up the controller at "Lipoly Normal". Is it possible that this setting causes this attitude? Do you think it's ok/safe to use Lipoly High at this setup? Thanks :)