RC-Monster Forums - View Single Post

mabu · 12.09.2007, 10:02 AM

Thanks ... yesterday i did two runs - now it's amazing

At the end of the second test run the car stopped. So i thought the LVC protection was on.
But today i loaded the 3200mA Lipo and loaded only 1600mA... i wanted to do another run to make a video - the motor did a well for about 2 minutes .. afterwards the motor stopped like yesterday. This time the LVC protection could not be on ... I checked the voltage per cell at my loader - 3.8V per cell.

I dissambled the motor and the motor spin well, after some stop and go the motor did not start like yesterday and the "video run" today.

What can i do now?
The motor is not locked or grinded anywhere - i hold it in my hand of cource ;)

	(#5)
mabu RC-Monster Carbon Fiber Offline Posts: 50 Join Date: Nov 2007 Location: Austria, Graz	12.09.2007, 10:02 AM Thanks ... yesterday i did two runs - now it's amazing At the end of the second test run the car stopped. So i thought the LVC protection was on. But today i loaded the 3200mA Lipo and loaded only 1600mA... i wanted to do another run to make a video - the motor did a well for about 2 minutes .. afterwards the motor stopped like yesterday. This time the LVC protection could not be on ... I checked the voltage per cell at my loader - 3.8V per cell. I dissambled the motor and the motor spin well, after some stop and go the motor did not start like yesterday and the "video run" today. What can i do now? The motor is not locked or grinded anywhere - i hold it in my hand of cource ;)