RC-Monster Forums - View Single Post

lincpimp · 12.16.2007, 03:08 AM

I am using a JR Z9100T in my Revo and it works very well, super fast and can turn the truck if you hold the front wheels!

I run it and a futaba 3050 (for brakes) in my tekno converted revo with a ccbec set for 6.5 volts! Neither servo even gets warm, so I can recommend both for use at 6.5v.

I will say that the JR is alot quieter than my hitec 5997 that is in my LSP. I have witnessed the "knock off" servo that sspconcepts was talking about and it works as well as the hitec it is based on, only maybe a little louder!

I have had excellent success with futaba servos, both their brand and the ones they relabel for other companies. However I have never used a servo that did not have enough torque for the job!

	(#1)
lincpimp Check out my huge box! Offline Posts: 11,935 Join Date: Aug 2007 Location: Slidell, LA	12.16.2007, 03:08 AM I am using a JR Z9100T in my Revo and it works very well, super fast and can turn the truck if you hold the front wheels! I run it and a futaba 3050 (for brakes) in my tekno converted revo with a ccbec set for 6.5 volts! Neither servo even gets warm, so I can recommend both for use at 6.5v. I will say that the JR is alot quieter than my hitec 5997 that is in my LSP. I have witnessed the "knock off" servo that sspconcepts was talking about and it works as well as the hitec it is based on, only maybe a little louder! I have had excellent success with futaba servos, both their brand and the ones they relabel for other companies. However I have never used a servo that did not have enough torque for the job!