RC-Monster Forums - View Single Post - The brushless serpent 1/8th onroad project!

Mod Man · 06:14 PM

Sounds cool.

Hmm, DA might do the angles. But, I am not sure. If he knew there was a good market for them, he would do it. Heck, I can email him and ask. I know him pretty well. I would even be willing to stock it with the rest of my inventory if he is willing to make it. Then I could sell it in small pieces if needed.

Sure we could get together some time. I have a number of projects going on (brushless hydro, crawler, a couple 1/10 scale cars, my top speed car, a recumbent E-bike, a one off TXT axle truck and a couple helis). However, there are never more than two or three that are together and runnng at any one time.

Oh, I am also constantly upgrading my shop. I am upgrading my CNC to 4 axis along with a new computer and new software. I am in the process of installing a trunion table for 5 axis on my manual Taig mill, and I am making my own heads for my mills. My CNC currently boasts a AXI outrunner driven by a 24 volt power supply through an HV110 controlled by a Astro Flight servo tester.

Waayyyy too many projects!

	(#100)
Mod Man RC-Monster Carbon Fiber Offline Posts: 156 Join Date: Nov 2007	01.20.2008, 06:13 PM Sounds cool. Hmm, DA might do the angles. But, I am not sure. If he knew there was a good market for them, he would do it. Heck, I can email him and ask. I know him pretty well. I would even be willing to stock it with the rest of my inventory if he is willing to make it. Then I could sell it in small pieces if needed. Sure we could get together some time. I have a number of projects going on (brushless hydro, crawler, a couple 1/10 scale cars, my top speed car, a recumbent E-bike, a one off TXT axle truck and a couple helis). However, there are never more than two or three that are together and runnng at any one time. Oh, I am also constantly upgrading my shop. I am upgrading my CNC to 4 axis along with a new computer and new software. I am in the process of installing a trunion table for 5 axis on my manual Taig mill, and I am making my own heads for my mills. My CNC currently boasts a AXI outrunner driven by a 24 volt power supply through an HV110 controlled by a Astro Flight servo tester. Waayyyy too many projects! Last edited by Mod Man; 01.20.2008 at 06:14 PM.