RC-Monster Forums - View Single Post - Project outrunner e-savage

Pedebeater · **Project outrunner e-savage -** 02.01.2008, 05:35 PM

I was inspired to do something like this by a friend who has an outrunner warhead (Takedown). He helped me out a lot with picking out the right motors. If I did this I would be using it as a direct drive setup. So I would not have to use the center tranny. Using outrunners can have many advantages. Such as loads of torque while still having amazing top end speed, efficiency, and less heat.

Here they are!
http://www.hobbycity.com/hobbycity/s...idProduct=4658

http://www.hobbycity.com/hobbycity/s...idProduct=4912

I would also like to know more information on outrunners in general. Like should I be basing my decision mainly on length or width?

I have not seen this done to a e-savage yet and would love to do something new. So please let me know what you think.

	(#1)
Pedebeater RC-Monster Carbon Fiber Offline Posts: 136 Join Date: Jan 2008 Location: Oshkosh WI	Project outrunner e-savage - 02.01.2008, 05:35 PM I was inspired to do something like this by a friend who has an outrunner warhead (Takedown). He helped me out a lot with picking out the right motors. If I did this I would be using it as a direct drive setup. So I would not have to use the center tranny. Using outrunners can have many advantages. Such as loads of torque while still having amazing top end speed, efficiency, and less heat. Here they are! http://www.hobbycity.com/hobbycity/s...idProduct=4658 http://www.hobbycity.com/hobbycity/s...idProduct=4912 I would also like to know more information on outrunners in general. Like should I be basing my decision mainly on length or width? I have not seen this done to a e-savage yet and would love to do something new. So please let me know what you think.