RC-Monster Forums - View Single Post

Sammus · 02.05.2008, 07:37 PM

Another question related. I've come to realise that my L can feigao will be absolute overkill for ye olde rusty, so I'm thinking heat may not be much of an issue from my motor (Specially since it will only be at about 30k rpm - will have to be geared pretty tall though).

Anyway, the point of the post is that I've heard of the pressed endbells of these feigao motors popping off for some reason - instead of spending $30 odd on a heatsink/clamp thing to prevent this, can you just smear a bit of loctite or ca glue or something around the endbell to stop it happening?

Cheers

	(#3)
Sammus RC-Monster Titanium Offline Posts: 1,161 Join Date: Jan 2008 Location: All over Australia.	02.05.2008, 07:37 PM Another question related. I've come to realise that my L can feigao will be absolute overkill for ye olde rusty, so I'm thinking heat may not be much of an issue from my motor (Specially since it will only be at about 30k rpm - will have to be geared pretty tall though). Anyway, the point of the post is that I've heard of the pressed endbells of these feigao motors popping off for some reason - instead of spending $30 odd on a heatsink/clamp thing to prevent this, can you just smear a bit of loctite or ca glue or something around the endbell to stop it happening? Cheers