RC-Monster Forums - View Single Post

jadesportster · 09:07 PM

Need some help here guys.

I only got 2 set screws with fabricated pins on the other half and I think those are used to replace the stampede part number 4628R on the transmission output shaft, but what type of pin do I secure between the hole in the axle and the coupling? I've got regular set screws, but wont those just spin around the axle shaft?

It's almost like I need to use the OEM pin with the FLM CVD kit and secure the axle to the coupling using the supplied set screw/pin combination except they're the wrong size...

Anyone know the proper setup for the CVD's to the tranny coupling and to the axle?

Cheers

???

	(#1)
jadesportster RC-Monster Stock Offline Posts: 28 Join Date: Feb 2008	FLM xtended CVD question - 02.26.2008, 04:35 PM Need some help here guys. I only got 2 set screws with fabricated pins on the other half and I think those are used to replace the stampede part number 4628R on the transmission output shaft, but what type of pin do I secure between the hole in the axle and the coupling? I've got regular set screws, but wont those just spin around the axle shaft? It's almost like I need to use the OEM pin with the FLM CVD kit and secure the axle to the coupling using the supplied set screw/pin combination except they're the wrong size... Anyone know the proper setup for the CVD's to the tranny coupling and to the axle? Cheers ??? Last edited by jadesportster; 02.26.2008 at 09:07 PM.