RC-Monster Forums - View Single Post

mahazael · **gearing for a Neu 1515 /1.5d for my 3905 -** 03.18.2008, 10:30 PM

I just managed to nab one of these bad boys. 1515 /1.5d

I don't want to buy a bunch of 5mm 32p pinions so does anyone have any recommendations for gearing. I can pick up any spur, but I need some suggestions on a few pinions. I'll be running dual 2s lipo's for 4s25c setup.

I am looking to get some good run times from my packs while getting a good ammount of torque and some good high speeds. I am looking for good bashing times and some 'wow' factor.

I was thinking of running around a 14t or 15t for an FGR of 25.34 or 23.65 respectively for some low temps and good run times.

I am also considering running two 3s25c packs in this bad boy. I will be running a Quark Monster Pro.

Ideas on either setup?

	(#1)
mahazael RC-Monster Stock Offline Posts: 29 Join Date: Jan 2007 Location: northern cali	gearing for a Neu 1515 /1.5d for my 3905 - 03.18.2008, 10:30 PM I just managed to nab one of these bad boys. 1515 /1.5d I don't want to buy a bunch of 5mm 32p pinions so does anyone have any recommendations for gearing. I can pick up any spur, but I need some suggestions on a few pinions. I'll be running dual 2s lipo's for 4s25c setup. I am looking to get some good run times from my packs while getting a good ammount of torque and some good high speeds. I am looking for good bashing times and some 'wow' factor. I was thinking of running around a 14t or 15t for an FGR of 25.34 or 23.65 respectively for some low temps and good run times. I am also considering running two 3s25c packs in this bad boy. I will be running a Quark Monster Pro. Ideas on either setup?