RC-Monster Forums - View Single Post - cut a flat spot in shaft for the pinion set screw?

mkrusedc · 06:30 PM

I haven't put a flat spot on my Neu yet. The pinion came off twice before I used loctite. So far no problems, but I am a basher. If mine comes off I won't lose a race.

I have used a soldering iron to heat the grub screw and then used a pinion puller to get stuck pinions off.

	(#2)
mkrusedc NeuMaxx Offline Posts: 1,286 Join Date: May 2007 Location: Near New Orleans	04.10.2008, 05:19 PM I haven't put a flat spot on my Neu yet. The pinion came off twice before I used loctite. So far no problems, but I am a basher. If mine comes off I won't lose a race. I have used a soldering iron to heat the grub screw and then used a pinion puller to get stuck pinions off. E-Maxx Neu 1515/1y/f, MGM, 5s, FLM, UE, RPM, single speed Last edited by mkrusedc; 04.10.2008 at 06:30 PM.