RC-Monster Forums - View Single Post - cut a flat spot in shaft for the pinion set screw?

mkrusedc · 06:44 PM

I have not used that one but it says for motor shafts 2.0mm-3.2mm in diameter. Neus are 5mm shafts.

Here is one that should work 1mm-5mm shafts.

http://www.lynxmotion.com/Product.as...&CategoryID=72

	(#4)
mkrusedc NeuMaxx Offline Posts: 1,286 Join Date: May 2007 Location: Near New Orleans	04.10.2008, 06:34 PM I have not used that one but it says for motor shafts 2.0mm-3.2mm in diameter. Neus are 5mm shafts. Here is one that should work 1mm-5mm shafts. http://www.lynxmotion.com/Product.as...&CategoryID=72 E-Maxx Neu 1515/1y/f, MGM, 5s, FLM, UE, RPM, single speed Last edited by mkrusedc; 04.10.2008 at 06:44 PM.