RC-Monster Forums - View Single Post

RC-Monster Mike · 02.21.2005, 10:35 PM

1/8" is easier to work with, but you need to be careful and install the pinion as close to the motor as you can (don't mount the pinion out on the very end of the shaft). These will allow any maxx sized pinion to fit. The 5mm shaft is much stronger, but pinions are not as cheap or as easy to come by.

	(#9)
RC-Monster Mike Site Owner Offline Posts: 4,915 Join Date: Nov 2004 Location: PA	02.21.2005, 10:35 PM 1/8" is easier to work with, but you need to be careful and install the pinion as close to the motor as you can (don't mount the pinion out on the very end of the shaft). These will allow any maxx sized pinion to fit. The 5mm shaft is much stronger, but pinions are not as cheap or as easy to come by.