RC-Monster Forums - View Single Post - track tested my truggy and brushless slash

rootar · 05:14 PM

finally quit raining today and the dried up enough to run the slash some and WOW rolling 30mph wheelies are a piece of cake, i found it set alot better and didnt squat as much if you run 5/8" of preload collars on the rear and 3/16" preload collars in the front.

watching this scale looking truck do wheelies is just awesome, it jumps pretty good (nothing over 20 feet long and 4 feet high) so far but later in the week ill take it over to the big jumps.

i come back inside to trim just a tad more off the body i could hear it rubbing the rea tires when taking a sweeper under alot of throttle and i dont wanna tear the tires up like someone else already did. I also bumped up to a 13 tooth pinion instead of the 12 as my motor was running a little warm due too me not being able to control from going WOT all the time.

ill see if i can get a video here in a little bit.

	(#10)
rootar RC-Monster Titanium Offline Posts: 1,803 Join Date: Aug 2005 Location: arkansas	06.29.2008, 03:24 PM finally quit raining today and the dried up enough to run the slash some and WOW rolling 30mph wheelies are a piece of cake, i found it set alot better and didnt squat as much if you run 5/8" of preload collars on the rear and 3/16" preload collars in the front. watching this scale looking truck do wheelies is just awesome, it jumps pretty good (nothing over 20 feet long and 4 feet high) so far but later in the week ill take it over to the big jumps. i come back inside to trim just a tad more off the body i could hear it rubbing the rea tires when taking a sweeper under alot of throttle and i dont wanna tear the tires up like someone else already did. I also bumped up to a 13 tooth pinion instead of the 12 as my motor was running a little warm due too me not being able to control from going WOT all the time. ill see if i can get a video here in a little bit. Last edited by rootar; 06.29.2008 at 05:14 PM.