RC-Monster Forums - View Single Post - What motor to run with MM for crt.5 or LS10?

R00ST · 08.29.2008, 12:40 AM

Thanks, that really helps! I am familiar with the E-revo... I have built two of them over time. (one with novak 6.5 the other with 9920/9xl on 16 cells...was a fun truck!)

II think im going to go for the crt.5 with the rcm conversion to help add the length, then use tires/wheels to get the width I want.

To run those 12mm hexes for the slash tires, did you use traxxas hexes? If so, do they fit the axle tight with no slop? I have some integy adaptors (17mm) for my rustler, and was hoping to get confirmation that the axles are the same size to make sure they dont fit sloppy on the axle. I have lots of 1/8 buggy tires I use on my rustler which I was hoping to transfer to the crt.5.

Thanks
Mike

	(#21)
R00ST RC-Monster Carbon Fiber Offline Posts: 284 Join Date: Jun 2005	08.29.2008, 12:40 AM Thanks, that really helps! I am familiar with the E-revo... I have built two of them over time. (one with novak 6.5 the other with 9920/9xl on 16 cells...was a fun truck!) II think im going to go for the crt.5 with the rcm conversion to help add the length, then use tires/wheels to get the width I want. To run those 12mm hexes for the slash tires, did you use traxxas hexes? If so, do they fit the axle tight with no slop? I have some integy adaptors (17mm) for my rustler, and was hoping to get confirmation that the axles are the same size to make sure they dont fit sloppy on the axle. I have lots of 1/8 buggy tires I use on my rustler which I was hoping to transfer to the crt.5. Thanks Mike